Publicidad
Idiomas disponibles
Idiomas disponibles
The positioning and electrical and gas installation should always be carried out by an AUTHORISED TECHNICIAN,
observing the standards of each country.
It is advisable to install an extraction hood for the optimum operation of the appliance.
Place the appliance in a well-ventilated place.
Level and adjust the height of the appliance. Fig. 1
An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a minimum of 3
mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not
fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in
diagram no. 2.
To access the appliance's electrical connection terminal strip (refer to Fig. 2), open the front panel and
then loosen the screws on the switchboard's lid. Pass the cable sleeve through the stuffing box located in
the switchboard and connect it to the terminal strip.
VERY IMPORTANT: Before putting the switchboard top on, fasten the electric supply cable tightly to the stuffing
box.
When several appliances are installed in series, they should be earthed to each other using the point assigned for
this purpose, located in the appliance's base, at the back.
The water intake and its location within the appliance are defined in the "General Dimension and connection" with
the letters "AF and AC". The water pressure must be between 2 and 4 bar and the maximum temperature is 60ºC.
The water intake in the machines is ¾". To fill up the pan turn the water inlet tap as shows Fig. 4 to the required
position.
Usage
IMPORTANT: Never start up the appliance without having previously filled the tub, otherwise overheating would
seriously damage the machine.
When the appliance has been installed, clean the vat with water and detergent and never with gritty or abrasive
products.
Do not use the hose for external cleaning.
Turning the resistors on and off
a)
Activate the power switch.
b)
Turn the adjustment thermostat control clockwise until pilot light 4 turns on.
c)
Turn the regulator control clockwise to the required position, pilot light 5 turns on.
d)
To disconnect, turn the thermostat control anticlockwise to position 1- OFF (•).
1.- INSTALLATION
Positioning and levelling
Electrical connection
Water connection
2.- USE
Turning the appliance on
15
Publicidad
