Preparing For Operation - Crusader Walkabout El Manual Del Propietario

PrEPArING FOr OPErATION

1. Unlatch and remove the top cap and pull out the
Micro Cloth filter. Check to see that the dome filter
has not shifted during shipping (Figure A). Reinstall the
Micro Cloth filter, making sure that the lip of the filter
completely covers the rim of the vacuum (Figure B).
2. Install an Intercept Micro Filter (if there is not one
already installed) by sliding the gasket of the Micro
Filter over the inlet on the inside of the top cap (Figure C).
At the beginning of each shift, the filters should be checked.
Empty or replace as necessary.
NOTE: Never use an Intercept Micro Filter without
the Micro Cloth filter. (The Micro Cloth filter's
rubber gasket provides the seal.)
3. Replace the cap, making sure that the latches catch
correctly. Push the hose into the cap opening.
4. Twist the aluminum wand into the hose (Figure D).
Check hose cuffs at both ends to make sure that they
are tight.
5. Loosen the shoulder straps and waist belt. In an open
area, lift the vacuum by one shoulder strap and slide
your free arm into the other strap (Figure E).
6. Fasten the waist belt snugly and make sure the
weight is resting comfortably on your hips (Figure F).
7. Thread the extension cord through the Schulte Cord
Holder on the waistbelt (Figure F). DO NOT tie
extension cord and power cord together. Doing so
will result in damage to both cords and will not be
covered under warranty (Figure G).
8. To attach tools to a 1
the plastic nut at the end of the wand, insert the tool,
and retighten the nut. To ensure the copper ring stays
in place, NEVER remove the nut.
6
/ " aluminum wand, LOOSEN
1
2
Figure F
Figure A
Figure B
Figure C
Figure D
Figure E
Figure G