Preparing For Use With A Power Nozzle - Crusader Walkabout El Manual Del Propietario

PrEPArING FOr uSE WITH A POWEr NOZZLE

1. A commercial-rated power nozzle with a three-pronged
plug must be used with a commercial-rated vacuum.
2. Push the hose cuff of the electrified hose into the cap
opening.
3. Feed the cord attached to the hose under the handle of
the top cap and behind the vacuum for easier cord
management. Then plug it into the receptacle on the
base of the vacuum (Figure H).
4. The rotating brush roll could cause damage to bare floors.
Be sure the brush roll is stationary for bare floors and rotating for carpet.
5. Read the additional instructions included with the power nozzle.
PrEPArING FOr uSE AS A CANISTEr
1. With a screwdriver, remove the two upper and lower
mounting screws (Figure I).
2. Pull the backplate and spacers off and lay the vacuum
down on the back swivel wheel (Figure J). Store the
spacers, screws and backplate together where they will
not be lost.
3. To put in backpack mode again, reverse the steps.
O P E r A T I O N
Figure H
Figure I
Figure J
7