Operation - Husky 8200441 Guía De Uso Y Cuidado

Operation

1
Dry Pick-up
□
The foam filter (N) and reusable dry filter (M) may be used
to pick up dust and dry material; you must install both to
ensure proper filtration. lf the vacuum has been used to
pick up liquids, the foam filter must be cleaned and dried
before installing for dry pick up. The filter must always be
in the correct position to reduce the risk of leaks and
possible damage to the vac. Make sure that the filter is
completely covering the filter cage and that the clamp ring
is as close to the lid as possible. Make sure there are no
gaps between the filter and the lid (See illustration). It is
very important to assemble the filter to the cage without
allowing any possible leaks or tears. Any leaks will allow
the picked up debris to be blown out of the blowing port
and back into the surrounding environment.
□
When using your vacuum to pick up very fine dust, it will be
necessary to empty the dust tank and clean or replace the
filter at more frequent intervals to maintain peak vacuum
performance.
NOTE: A dry filter is necessary to pick up dry material. If you
use your vacuum to pick up dust when the filter is wet, the
filter will clog quickly and be very difficult to clean. If the filter
gets wet, replace it before continuing to do dry pickups.
3
Blower
This vacuum contains a blowing feature. Follow the steps below to
use the vacuum as a blower.
□
Locate the blower port (F) on your vacuum.
□
Insert one end of the 2.13 m x 4.76 cm / 7 ft. x 1-7/8 in.
hose (J) into the blower port (F).
□
Turn the vacuum "ON".
M
Clamp ring
2
Wet Pick-up
□
Remove the disposable filter bag and reusable dry filter (M)
and replace it with the foam filter (N) when you do wet
pick-ups.
□
This wet/dry vacuum is equipped with a float mechanism
which will rise automatically to cut off the airflow when the
liquid in the tank reaches a predetermined level. When this
happens, turn off the vacuum, unplug the power cord, and
empty the dust tank. You will know that the float has shut
the airflow off because the suction ceases and the motor
noise becomes higher in pitch due to increased motor
speed. The liquid capacity may vary with the rate of pickup.
IMPORTANT: To reduce the risk of damage to the vacuum,
do not run the motor with the float in raised position. Wet pick
up accessories should be washed periodically.
Float in raised position
J
6
N
F