Care And Maintenance - Husky 8200441 Guía De Uso Y Cuidado

Care and Maintenance

FILTER REPLACEMENT – REPLACE WITH SKU # 335210
WARNING: To reduce the risk of injury from accidental starting, unplug the power cord before changing or cleaning the filter. Your
filter should be cleaned often to maintain peak vacuum performance.
WARNING: Do not remove the filter cage and float. The float prevents water from entering the impeller and damaging the motor. The
cage prevents fingers from touching the moving impeller.
IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the reusable dry filter before using the vacuum for
dry pickups and always reinstall the foam filter before using the vacuum for wet pickups.
IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears in it. Even a small hole can
cause dust to come out of your vacuum. Replace it immediately.
NOTE: Before installing the filter on the vacuum, clean the area of the lid so that the clamp ring will seal the bag against the lid and
stop small particles from bypassing the filter bag. If the filter is clean and not damaged, replace it on the filter cage. If it cannot be
reused, place a new filter over the filter cage.
NOTE: Clean the filter in an open area.
CLEANING
To keep your wet/dry vacuum looking its best, clean the outside with a cloth dampened with warm water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash the tank thoroughly with warm water and mild soap.
3. Wipe out with a dry cloth.
STORAGE
Before storing your vacuum, the dust tank should be emptied and cleaned. The cord should be wrapped and hung on the unit and the
accessories should be kept in the accessory holder so they can be readily available. The vacuum should be stored indoors.
7
Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM