Twin Star 23E05-R Manual De Operacion Del Propietario página 6

REPLACING THE
DOWNLIGHT BULBS
models 28E05 and 33E05
This fireplace uses (2) clear 120V, 4 Watt E12 sock-
et light bulbs (open, small base, night light type).
Tools required (1) Philips head screw-driver. For
convenience, if a bulb burns out, it is a good idea
to replace both bulbs at the same time.
1.) Turn the master power switch off, then
UNPLUG the power cord from the wall.
2.) If the fireplace has been operating, let the unit
cool for 2 hours.
3.) Open control panel door, locate and remove
the 3 screws in/between the door and main
body of the insert (illustration 1).
4.) Close the control panel door and pull the top
glass bracket towards you, away from the front
of the insert (illustration 2).
5.) Open the control panel door, using your hands
grab the rubber glass trim which is split in the
top center (illustration 2). Gently pull up on
the rubber glass trim, this will lift the front
glass up (illustration 3).
6.) Pull the glass only 1/2 of the way up and stop.
Reach underneath to access the downlight
bulbs (illustration 3)
7.) Unhook the light bulb spring clip from the
bulbs (illustration 4) then, unscrew the bulbs.
After replacing the bulbs make sure to replace
the light bulb spring clip.
8.) Follow the same steps in reverse order to rein-
stall the glass and the top glass bracket.
3 SCREWS
RUBBER GLASS TRIM
REACH UNDER HERE
E-6
illustration 1
illustration 2
TOP GLASS BRACKET
illustration 3
illustration 4
LIGHT BULB HOLDING SPRING