Energy Saving Ideas; How To Remove And Replace Light Bulbs - JENN-AIR JCB2058GEB Guia Del Usuario

R O
EMOVING DORS
F R
ROM EFRIGERATOR
1. Remove all food.
2. Disconnect refrigerator.
3. Clean the following items using the
appropriate instructions in the Care
and Cleaning table on page 16.
– Walls, floor and ceiling of cabinet
interior
– Drawers, shelves and gaskets
according to the instructions in
this section.
4. Pay special attention to clean all
crevices by completing the following
steps.
– Dilute mild detergent and brush
solution into crevices using a
plastic bristle brush.
– Let stand for 5 minutes.
– Rinse surfaces with warm water.
Dry surfaces with a soft, clean
cloth.
5. Wash and dry all bottles, containers
and jars. Discard spoiled or expired
items.
6. Wrap or store odor-causing foods in
tightly sealed containers to prevent
reoccurring odors.
7. Connect power to refrigerator and
return food to unit.
8. After 24 hours, check if odor has been
eliminated.
If odor is still present:
1. Remove drawers and place on top
shelf of refrigerator.
2. Pack refrigerator and freezer sections
– including doors – with crumpled
sheets of black and white newspaper.
3. Place charcoal briquettes randomly
on crumpled newspaper in both
freezer and
compartments.
4. Close doors and let stand 24-48
hours.
E
NERGY
➢ Avoid overcrowding refrigerator
shelves. This reduces air circulation
around food and causes refrigerator
to run longer.
➢ Avoid adding too much warm food to
unit at one time. This overloads
compartments and slows rate of
cooling.
➢ Do not use aluminum foil, wax paper,
or paper toweling as shelf liners. This
decreases air flow and causes unit to
run less efficiently.
➢ A freezer that is
efficiently.
➢ Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers or
other heat producing appliances. If
this is not possible, isolate exterior by
using a section of cabinet or an added
layer of insulation.
➢ Refer to recommended control
settings on page 10.
➢ Clean door gaskets every three
months
instructions on page 16. This will
assure that door seals properly and
unit runs efficiently.
➢ Take time to organize items in
refrigerator to reduce time that door
is open.
➢ Be sure your doors are closing
securely by leveling unit as instructed
on page 9.
➢ Clean condenser coils as instructed
on page 16 every 3 months. This will
increase energy efficiency and cooling
performance.
refrigerator
S I
AVING DEAS
2 full runs most
⁄
3
according to cleaning
17
R R
EMOVE AND
L B
IGHT ULBS
WARNING:
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before replacing light bulb. After
replacing light bulb, connect power.
CAUTION:
To avoid personal injury or property
damage, observe the following:
➢ Allow light bulb to cool.
➢ Wear gloves when replacing light
bulb.
FRESH FOOD SECTION
1. Slide shield toward
compartment
to release from
light assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no
greater than 40 watts.
4. Replace light bulb
cover by inserting
tabs on light
shield into liner holes on each side of
light assembly. Slide shield toward
front of unit until it locks into place.
DO NOT force shield beyond
locking point. Doing so may damage
light shield.
FREEZER
1. Pinch rear tabs on light cover and pull
straight down.
2. Remove light bulb.
3. Replace bulb with
appliance bulb no
greater than 40
watts.
4. Insert front tabs of light cover into
freezer liner and snap rear portion
over light assembly until rear tabs
engage.
EPLACE
back of
$
%