Ups Setting - PowerWalker 1000 LCD Manual De Instrucciones

FU
EE
FA
BR
EN

3-5. UPS Setting


Parameter 2
1: Output voltage setting

Interface
02: Frequency Converter enable/disable

Interface
Parameter 1
Parameter 3
Setting
Parameter 3: Output voltage
For 200/208/220/230/240 VAC models, you may choose the
following output voltage:
200: presents output voltage is 200Vac
208: presents output voltage is 208Vac
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac (Standard)
240: presents output voltage is 240Vac
For 100/110/150/120/127 VAC models, you may choose the
following output voltage:
100: presents output voltage is 100Vac
110: presents output voltage is 110Vac
115: presents output voltage is 115Vac
120: presents output voltage is 120Vac (Standard)
127: presents output voltage is 127Vac
Setting
Parameter 2 & 3: Enable or disable converter mode. You
may choose the following two options:
CF ENA: converter mode enable
CF DIS: converter mode disable (Standard)
Bypass frequency unstable
EEPROM error
Fan failure
Battery Replace
There are three parameters to set up the
UPS.
Parameter 1: It's for program
alternatives. Refer to below table.
Parameter 2 and parameter 3 are the
setting options or values for each
program.