Selecting Speed And Abrasive Belt; Stationary Work - Parkside PBSD 600 A1 Traducción Del Manual De Instrucciones Original

Selecting speed and abrasive belt

You can use the belt speed adjusting wheel
adjust the speed, even while the appliance is run-
ning. The optimum belt speed is dependent on the
workpiece or material being processed. We rec-
ommend carrying out a practice run to determine
the correct speed. In the table below, you will find
some recommended values which will help you de-
termine which belt and speed to use for which job.
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
│ GB │ IE
■ 20
to
Softwood
60
240
high (5–6)
Hardwood
60
180
high (5–6)
Chipboard
60
150
high (5–6)
Removing paint/
varnish
60
––
high (5–6)
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/working
area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection

Stationary work

♦ Turn the additional handle
position.
♦ Turn the power tool as shown in the illustration
and place it on a stable worktop.
♦ Fit the two screw clamps
provided and clamp the power tool tightly.
Rubbing down
paintwork/varnish
150
320
low (1–2)
Removing rust from
steel
40
120
medium/high (3–4)
Plastics
120
240
low/medium (2–3)
Non-ferrous metals
(e.g. aluminium)
80
150
medium/high (3–4)
to the horizontal
in the recesses
PBSD 600 A1