Uline H-2957 Manual De Usuario página 16

OPERATING ISSUE
Turntable does not stop at
home.
Film carriage does not move.
The carriage does not raise
in a wrapping cycle.
The carriage does not stop
at the top of product in a
wrapping cycle.
The carriage does not lower
after the completion of top
wraps count.
PAGE 16 OF 51
TROUBLESHOOTING CONTINUED
CAUSES
Are the parameters of the frequency drive set properly?
Does the indicator light of the turntable home proximity
switch turn on when the table is at home position? If not,
clear obstructions and adjust sensor to pick up target.
Now does the indicator light turn on?
Film carriage speed is not set high enough.
Resistance of potentiometer not equal to 5KΩ across.
The carriage limit switch lever arm does not move freely.
The limit switch is not wired properly.
The LED display is not on the film carriage frequency drive.
The frequency drive is not functioning. Push the "STOP"
button. Wait 60 seconds, and then pull the button out. Is
the fault cleared?
The frequency drive is not connected properly to motor.
The parameters of the frequency drive are not set
correctly.
The film carriage motor is not running.
None of the recommendations work.
The product height detection photoelectric sensor does
not see the product.
The indicator light does not turn on as the turntable passes
the home position. If not, clear obstructions and adjust
sensor to pick up target. Now does the indicator light turn
on?
The film carriage product height detection photo sensor
does not have power.
The sensor sees objects other than the product.
The indicator light does not turn on as the turntable passes
the home position. If not, clear obstructions and adjust
sensor to pick up target. Now does the indicator light turn
on?
RECOMMENDATIONS
Restore drive parameter setting.
Tighten power wiring the sensor, replace if
necessary.
Adjust potentiometer towards 100% to set
speed.
Tighten wiring, replace dial if necessary.
Remove obstruction, and/or clean limit switch
head.
Tighten or replace limit switch as necessary.
Switch the film carriage circuit breaker on.
Refer to frequency drive manual for specific
fault.
Tighten or replace wiring as necessary.
Restore drive parameters setting.
Check film carriage motor for mechanical
restrictions.
Replace film carriage frequency drive.
Adjust the sensitivity of the sensor.
Tighten power wiring to the sensor, replace if
necessary.
Tighten power wiring to the sensor, replace if
necessary.
Adjust the sensitivity of the sensor.
Tighten power wiring to the sensor, replace if
necessary.
0120 IH-2957