Uline H-2957 Manual De Usuario página 17

OPERATING ISSUE
The film mandrel does not
rotate.
The film does not stay
attached to the product at
start.
The film does not stay
attached to the product in a
wrapping cycle.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 17 OF 51
TROUBLESHOOTING CONTINUED
CAUSES
The film carriage dancer bar limit switch is not positioned
correctly.
The indicator light does not turn on as the dancer bar is
pulled.
The LED display is not on the film delivery frequency drive.
The frequency drive is not functioning. Push the "STOP"
button. Wait 60 seconds, and then pull the button out. Is
the fault cleared?
The frequency drive is not connected properly to the motor.
The parameters of the frequency drive are not correct.
The film delivery motor is not running.
None of the recommendations work.
The film is not threaded correctly.
The film is not in good condition.
The acceleration parameter on the film delivery frequency
drive is not set properly.
The acceleration parameter on the turntable frequency
drive is not set properly.
The film is not threaded correctly.
The film is not in good condition.
The "Film Force" dial on the operator panel is not set
correctly.
Resistance of potentiometer not equal to 5KΩ across.
1-800-295-5510
uline.com
RECOMMENDATIONS
Adjust the switch so that it activates when the
dancer bar is pulled.
Tighten siring to the sensor, replace if
necessary.
Switch the circuit breaker on.
Refer to frequency drive manufacturers
manual for specific fault.
Tighten or replace wiring as necessary.
Restore drive parameters setting.
Check film carriage motor for mechanical
restrictions. Replace if necessary.
Replace film delivery frequency drive.
Refer to film loading diagram.
Use proper film.
Restore parameters as listed on the electrical
schematics.
Restore parameters as listed on the electrical
schematics.
Refer to film loading diagram.
Use proper film.
Make a small adjustment at a time to set the
film force.
Tighten wiring, replace dial if necessary.
0120 IH-2957