VDS ELB24-M2 Istrucciones De Uso página 13

Manual setting of the stroke with leaves delay and slowing down spaces
customized.
Following instruction are for a 2 leaves swing gate; in case of 1 single swing leaf
(dip 1 SW1 ON) the instruction regards only the motor M1.
Ÿ Close the gate and press once button PROGR.; led DL6 starts flashing.
Ÿ Press once button LAVORO; M1 leaf starts opening.
Ÿ As soon as M1 leaf has reached the position you want to set the slowing down,
press again the button LAVORO, the leaf will start the slowing down procedure.
If you don't want any slowing down, then ignore this topic and go further.
Ÿ After that, M1 leaf will hit the mechanical stopper in opening and automatically will
stop.
Ÿ Press again button LAVORO to start counting the delay of the leaves in opening;
Led DL6 flashes fast.
Ÿ Press again button LAVORO to stop the counting for the time to apply to the delay
in opening. Automatically M2 leaf starts opening.
Ÿ When M2 leaf has reached the position you want to set the slowing down, press
again button LAVORO, the leaf will start the slowing down procedure. If you don't
want any slowing down, then ignore this topic and go further.
Ÿ After that, M2 leaf will hit the mechanical stopper in opening and automatically will
stop.
Ÿ Press once again the button LAVORO. Leaf with M2 starts closing.
Ÿ When M2 leaf has reached the position you want to set the slowing down in clos-
ing, then press button LAVORO and the leaf will start the slowing down procedure.
If you don't want any slowing down, then ignore this topic and go further.
Ÿ After that, M2 leaf will hit the mechanical stopper in closing and automatically will
stop.
Ÿ Press remote button LAVORO to start counting the delay of the leaves in closing
(Led DL6 starts flashing quickly).
Ÿ Press again button LAVORO to stop the counting for the time to apply to the delay
in closing. Automatically M1 leaf starts closing.
Ÿ When M1 leaf has reached the position you want to set the slowing down in
closing, then press button LAVORO and the leaf will start the slowing down
procedure. If you don't want any slowing down, then ignore this topic and go
further.
Ÿ After that, M1 leaf will hit the mechanical stopper in closing and automatically will
stop.
Ÿ When the closing has finished, the control panel will automatically go out from the
programming and it will be ready to work.
WARNING: In case of re-adjustment of the trimmer RALL. or VELOC. it is
ABSOLUTELY necessary to repeat the setting.