Identification Of Parts; Before First Use - Evenflo 16790 Manual Del Usario

Identification of Parts

Bottle Flange Single Pump Unit
(30.5mm)
Valve
Membrane Sealing Disc
*28.0mm Flange Insert
* Additional sizes are available separately. See page 8.

Before First Use

IMPORTANT: Before using your breast pump, disassemble and sanitize
thoroughly. Always wash hands well with soap and water before handling
your pump.
1
A
B
Remove the pump unit A from
flange assembly B by pulling up on
pump unit, as shown.
Stand AC Adapter
Bottle Cap Ring Diaphragm
2
D
B
Remove diaphragm C and flange
insert D from flange assembly B.
4
3
E
To Sanitize Parts on the Stove:
Place disassembled pump parts (except the pump unit and AC adapter) in a
pan of boiling water for 5 minutes. Stir frequently. DO NOT allow parts to
rest on bottom of pan as they may melt or become damaged.
To Sanitize Parts in the Microwave:
These pump parts may be used with a microwave sanitization device
(except the pump unit and AC adapter). Please follow device manufacturer's
instructions.
DO NOT BOIL OR WASH
C
Pump Unit
Before EVERY Use
• Wash your hands with soap and water before handling your pump.
• Ensure parts are clean and dry. Refer to cleaning instructions on page 11.
• Use care when handling the valve/membrane assembly to avoid damage.
• Visually inspect the individual components for cracks, chips, tears,
discoloration or deterioration. In the event that damage to the device
is observed, please discontinue use until the damaged parts have
been replaced.
Unscrew bottle E and twist valve G to
F
remove from assembled flange unit F.
Remove membrane H from valve I.
G
WARNING
NEVER immerse pump unit or
AC adapter in water or attempt
AC Adapter
to sanitize in a microwave oven.
Damage to parts and oven may
occur.
Single
5
Before First Use
I
H