ABB ACSM1-04 Guia De Inicio Rapido página 8

8
• Set the jumpers on the control unit to the
appropriate position:
J1 – Determines whether Analogue input AI1
is used as a current or voltage input.
Current
7
AI1
AI2
8
J2 – Determines whether Analogue input AI2
is used as a current or voltage input.
Current
7
AI1
AI2
8
J3 – Drive-to-drive link termination. Set to
ON if the drive is the last unit on the link.
Termination ON
T
Continue with drive start-up according to the
instructions in the appropriate Firmware
Manual.
Quick installation guide - ACSM1-04
Voltage
7
AI1
AI2
8
Voltage
7
AI1
AI2
8
Termination
OFF
T