Chapter 4. Maintenance Operations. Recommendations - gala gar GALA MIG 3000 Manual Técnico De Instrucciones

3.3 OPERATION CONTROLS. GALA MIG 3800.
P- DIGITAL VOLTMETER. (Optional)
It measures the voltage of the welding circuit.
Q- DIGITAL AMMETER. (Optional)
It measures the intensity of the welding circuit.
R- ON-OFF INDICATOR.
Equipment ON/OFF indicator light. It must stay ON when activating control N. If not, fuse T could have
"BLOWN", fault in the mains, etc.
T- FUSE-HOLDER.
Control circuit protection fuse system.
U- INCREMENTAL TAP-CHARGER.
This enables the correct welding voltage to be selected within the chosen range. It has 10 selection levels,
which will permit the best adjustment for each specific job.
V – ON/OFF SWITCH. SCALE SWITCH.
This switch is used to switch the power source on and also to select the regulation scale (2 scales).
3.4 WIRE-FEED UNITS. OPERATION CONTROLS.
In order to carry out a correct operation, please read the wire-feed units instructions manual.
4. MAINTENANCE OPERATIONS. RECOMMENDATIONS.
Before carrying out any operation on the machine or gun, we must place switch I of the equipment in "O"
position of machine disconnected. Specialized personnel must handle the machine to carry out maintenance
and repair operations.
BLOW THE INSIDE OF THE MACHINE WITH COMPRESSED AIR FROM TIME TO TIME.
PLACE THE EQUIPMENT SOMEWHERE WHERE CLEAN AIR IS RENEWED.
KEEP THE MACHINE PANELS CLOSED.
DO NOT DISCONNECT THE MACHINE IF IT IS HOT.
KEEP THE WELDING GUN IN GOOD CONDITIONS FOR USE.
GALA MIG 3000/3800.
P
Q
T
R V
U
21