Bluetooth Pairing - Plantronics DISCOVERY 610 Guia Del Usuario

"BEEP"
PoWEring on anD off
1. Power on the headset by pressing and
holding the call control button until the
headset status indicator glows blue. If
you are wearing the headset, you will
hear a beep when the power turns on.
The headset status indicator will flash
blue every 6 seconds when the headset
power is on.
NOTE When the headset is turned
on, the headset status indicator will
indicate the charge level of the headset.

Greater than 2/3 battery charge =
3 red flashes.
1/3 to 2/3 battery charge =
2 red flashes.
Less than 1/3 battery charge =
1 red flash.
2. Power off the headset by pressing the
call control button for 6-8 seconds until
the headset status indicator glows red
or until you hear the beep. The headset
status indicator remains unlit when the
power is off.

BlUEtootH Pairing

Before using your headset for the first
time, you must pair it with another
Bluetooth device, such as a mobile phone.
Make sure the headset is fully charged.
Look in your Bluetooth device manual for
the section that describes how to set up
a Bluetooth wireless connection.
1. Move through the menu selections
on your phone until the phone
display shows "Look for Devices, " or
equivalent, as a selection.
2. With your headset turned off, hold
down the call control button until the
headset status indicator briefly glows
blue, then flashes red and blue. The
headset is now in discovery mode and
will stay that way for 30 seconds.
6xx
3. On your phone, highlight and select
"Look for Devices, " or equivalent, to
activate the scan for the headset.
4. When the phone display shows the scan
results, select "6xx Plantronics". The
phone will continue to search for the
headset.
5. When the phone display asks for a
passkey, type "0000" and press Enter.
Your headset is now linked to your phone.