Recommendations For Use - jbc ADVANCED AR 5500 Manual Del Usuario

ENGLISH
SPECIFICATIONS
The AR 5500 is a repair station for desoldering
through-hole components by solder intake.
- AR 5500 230V
It is supplied with a desoldering iron Advanced DR
5600 and Advanced 2245 soldering handpiece.
Also all the Advanced soldering handpieces and the
hot tweezers PA 1200 or PA 4200 can be connected
to the station.
The station's components
- Handpiece 2245
with the cartridge 2245-003
- Desoldering iron DR 5600
with the tip 5600-003
- Soldering iron stand AD 8200
- Desoldering iron stand DR 8500 Ref. 0788500
- External desoldering air filter
- Spare filters
- Set of accessories
- Instruction manual
The AR 5500 station has the following
complementary products:
- Handpiece 2010
- Handpiece 2210
- Handpiece 2045
- Micro hot tweezers PA 1200
- Hot tweezers PA 4200
Control Unit technical specifications
- Maximum power soldering iron 50W.
- Maximum power desoldering iron 75W.
- Temperature selection of the soldering part:
100 to 371°C (±5%).
- Temperature selection of the desoldering part:
100 to 371°C (±5%).
- Station's maximum power: 175W.
- ESD protected housing.
Typical surface resistance: 10
- Complies with CE standards on electrical safety,
electromagnetic compatibility and antistatic
protection.
- Equipotential connector is earth connected to the
plug feed of the station.
- Weight of complete unit: 10.6 kg.
Ref. 5500200
Ref. 2245000
Ref. 2245003
Ref. 5600000
Ref. 5600003
Ref. 0268200
Ref. 0821830
Ref. 0781046
Ref. 0780593
Ref. 0780465
Ref. 2010000
Ref. 2210000
Ref. 2045000
Ref. 1200000
Ref. 4200000
5 11
-10 Ohms/square
2
- In the SOLD. connector you can only connect
handpieces 2010, 2210, 2045 and 2245 and the
hot tweezers PA 1200 or PA 4200.
- In the DESOLD. connector you can only connect
the desoldering iron DR 5600.

RECOMMENDATIONS FOR USE

For soldering and desoldering
- Clean the contacts and the printed circuit to
be desoldered of dust or dirt.
- Preferably select a temperature below 350°C.
Excess temperature may cause the printed
circuit tracks to break loose.
- The tip must be well tinned for good heat
conduction. If it has been inoperative for any
length of time, it should be retinned.
Safety measures
- Incorrect use of this tool may cause fire.
- Be cautious when using the tool in places
where inflamable products are stored.
- Heat can fire up inflamable products even
when they are not at sight.
- Do not use when the atmosphere is explosive.
- Place the tool back on its stand in order to let
it cool down before you store it.