Publicidad
Idiomas disponibles
Idiomas disponibles
Desoldering process
Use the tip model with a larger diameter than the
pad to be desoldered, so as to achieve maximum
aspiration and thermal efficiency.
1 Apply the desoldering iron tip so that the
component terminal penetrates within its
orifice.
2 When the solder liquefies, start gently to rotate
the desoldering tip so that the component's
terminal can be eased away from the sides.
3 Press then, not before, the vacuum pump
push-button just long enough to aspirate the
solder.
These
tips
are
specially designed
to clean the pads.
Ref.
A ø
5600
A ø (mm)
B ø (mm)
max. pin ø
(mm)
B ø
DESOLDERING TIPS
5600-011
5600-012 5600-013
5600-001
5600-002 5600-003 5600-004 5600-005 5600-006 5600-007
001 / 011
002 / 012
1.4
1.8
0.6
0.8
0.4
0.6
1
After pressing the desoldering key there is a
slight delay until the self-contained vacuum
pump stops, this is to make sure that the
vacuum circuit is completely empty.
If any solder remains are left on any terminal after
attempting to desolder it, resolder it with fresh
solder and repeat the desoldering operation.
003 / 013
0 0 4
2.7
3.2
1
1.3
0.8
1.1
5
ENGLISH
2
3
0 0 5
0 0 6
3.4
4.2
1.6
2
1.4
1.7
0 0 7
4.8
2.5
2.3
Publicidad
