Klarstein HeatPal Bloxx Manual De Usuario página 26

EN
26
Functions and Settings
Check up and make sure the plug voltage is accord with the service voltage
(220V-240V), then plug in. Put on the power switch at the back of the machine, enters
standby mode after "Bi" sound, all functions and display are closed.
1 Under standby model, all the pressing are invalid except POWER key. Press
POWER key, the device starts working. Press it again, the device turn off. The
default setting after turn on shows as below:
(a) PTC Low heating power indicator light on. Hing heating power indicator light off
(b) Timer: 0h (namely no timer), the indicator [H] off.
(c) Temperature:display default temperature. LED [°C] light on.
2 In working condition, press HEATER key to shift it from high heating power to low
heating power, second press turn into high power heating again, followed by
recycling.
(a) Operated at low heating power: low heating power indicator on (high heating
power indicator off).
(b) Operated at high heating power: high heating power indicator on (low heating
power indicator off).
3 In working condition, press SETTING key to set the time.
(a) Enter the timer setting mode, and the time indicator will be on, the LED light will
flicker per 0.5 second. At this time, press [+] or [-] key to set the timer (within
a range of 0-12 hours), the time will be added or minus by 1h every press.
When time of [+] or [-] press length is more than 2 seconds, the display rapidly
changes in 0.2s.
b) When enter into the timer setting mode, the timer that has been set before will
not be changed. You can reset the time, only when pressing [+] or [-] key, and
timer that you have set will effect at once.
c) If there is no operation to the keys after 5 seconds or press other keys except
[+] or [-], then the LED indicator [H] light on, and display will show the set timer.
And minus down by per hour. When the timer minus down to "0", the machine
turn off and enter standby mode.
d) If the timer set as "0", mean no timer is set. LED indicator [H] light off, and
display shows the room temperature. Machine enters standby mode.