SPECIFICATIONS
Amplifier Section
Power Output 4Ω (Watts
rms) *
Power Output 2Ω (Watts
rms) **
Power Output 1Ω (Watts
rms)
> 60% into 1Ω load at
Amplifier Efficiency
Signal to Noise ratio at
rated output power and
lowest impedance
Externally Bridgeable
Remote Gain Function
Distortion at Rated Power
Frequency Response
Linear Bandwidth
Damping Factor
Input Sensitivity Selection
Switch
Input Sensitivity
200mV-4V / 400mV-8V 200mV-4V / 400mv-8V
Supply Voltage Range
© 2009 Directed Electronics. All rights reserved.
HCCA25001
HCCA50001
750 x 1
1500 x 1
1500 x 1
3000 x 1
2500 x 1
5000 x 1
> 60% into 1Ω load at
max. power
max. power
>100 dB
>100 dB
No
yes (RGC2 supplied)
yes (RGC2 supplied)
0.2% THD+N
0.2% THD+N
20Hz to 300Hz
20Hz to 300Hz
±2.5dB
±2.5dB
20Hz to 300Hz
20Hz to 300Hz
±3dB
±3dB
> 100
> 100
Yes
Yes
9 to 16V
9 to 16V
Amplifier Section
Protection
Terminal Wire Gauge
Input Impedance
No
Fuse Size
Dimensions (L x W x H)
Crossover Section
High Pass
Crossover
Low Pass
Crossover
Intelli-Q
* Continuous 4Ω load 20Hz to 200Hz, < 1% THD, with input voltage at 14.4VDC.
** Continuous 2Ω load 20Hz to 200Hz, < 1% THD, with input voltage at 14.4VDC.
HCCA25001
HCCA50001
thermal,
thermal,
DC offset,
DC offset,
short protection,
short protection,
under-voltage,
under-voltage,
over-voltage
over-voltage
Power 0/1 AWG,
Power 0/1 AWG,
Remote 12-16 AWG,
Remote 12-16 AWG,
Ground 0/1AWG,
Ground 0/1AWG,
Speaker 8 AWG
Speaker 8 AWG
20 kΩ
250 Amp
500 Amp
19.75" x 10.3" x 2.5 "
24.75" x 10.3" x 2.5"
Continuously variable
Continuously variable
(20-200Hz)
(20-200Hz)
Continuously variable
Continuously variable
(50-300Hz)
(50-300Hz)
0–10dB boost
0–10dB boost
20 kΩ
6