Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE WASHER
Make sure that the washing machine is level and stable, and
securely connect the water inlet hose to the water source
and turn on the tap. If only one water inlet hose is being
used, it must be connected to the cold water inlet on the
washer and the Cold water setting must be used. Hang the
water drain hose and make sure it is properly in place and
will not move and plug the cord into a properly installed
and grounded outlet. The detergent tray is located inside the
washer, at the top of the drum, in the back (see Figure 10).
Refer to the detergent instructions for usage and quantity.
WASH PROGRAMS
HEAVY WASH
The Heavy Wash program is the default setting when the washer is turned on. It is the most common and
convenient program. The Wash, Rinse, and Spin function indicator lights will be lit, and the display will show the
approximate time remaining in the program (42 minutes).
When the program is set to Heavy Wash, the Function button can be used to select specific wash cycles, or run a
full wash. Pushing the Function button will cycle between: WASH/RINSE/SPIN → WASH → WASH/RINSE →
RINSE/SPIN → SPIN, allowing any combination of functions to be set.
To run the wash program:
1.
Push the ON/OFF button.
2.
Add Detergent.
3.
If desired, push the Function button to change wash cycles.
4.
Select the appropriate wash Load Size and water temperature setting.
5.
Push the Start/Pause button to begin the program.
While the washer is running, the Function indicator light for the current cycle will flash, and the display will count
down the approximate remaining time.
QUICK WASH
This function is for short washing times, and is suitable for lightly soiled items or clothing made from lightweight
materials.
1.
Press the Function button until the indicator light between Heavy and Quick is flashing.
2.
Select load size and water temperature.
3.
Add detergent.
4.
Press Start/Pause.
JEANS
Use this function to wash heavy fabrics or very soiled clothes.
1.
Press the Function button until the indicator light between Jeans and Anti-Wrinkle is lit.
2.
Select load size and water temperature.
3.
Add Detergent.
4.
PRESS START/PAUSE.
12
Figure 10
Detergent
Tray
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
