Control Panel - Danby DDR060BMPWDB Manual Del Propietário

OPERATING INSTRUCTIONS
FEATURES
1. Air Outlet

2. Control Panel

3. Handles (both sides)
4. Water Bucket
5. Air Inlet
6. Continuous Drain Outlet
7. Power Cord Storage Strap
8. Power Cord Storage Band
9. Pump Drain Outlet
10. Power Cord
1
2
4
CONTROL PANEL
2
1
7 8
5
3
6
7
8
9
10
3 4
5
9
10
CONTROL PANEL
1. Continuous button: Press to activate the
continuous dehumidifying operation.
2. Timer button: Press to set the timer.
3. Auto defrost light: The light will illuminate
when frost builds up on the evaporator coils.
The compressor will cycle off and the fan will
continue to run until the frost melts.
4. Bucket full light: The light will illuminate when
the bucket is full or incorrectly positioned
inside the cabinet. The compressor and fan
operation will stop as a safety feature. When
the bucket is emptied or correctly re-positioned
the dehumidifi er will resume operation
automatically.
5. Display and humidity adjust buttons:
• Shows the actual (± 5% accuracy) room humidity
level in a range of 30% to 90%. Otherwise,
displays selection when programming humidity
or timer.
• The humidity level can be set within a range of
35% to 85% relative humidity in 5% increments.
For drier air, set to a lower percentage value.
For more damp air, set a higher percentage
value.
6. Power button: Press to turn the dehumidifi er on
or off.
7. Pump button: Press to activate the drain pump.
Ensure that a drain hose is connected before
starting the pump.
6
8. Smart dehumidify: This function will
automatically adjust the humidity level with the
fl uctuating room temperatures. The humidity
level cannot be adjusted in this setting, it will
stabilize between 45% - 55%.
9. Filter button: The check fi lter light will illuminate
after 250 hours of operation. After cleaning the
fi lter, press the fi lter button to turn off the light.
10. Fan button: Press to select normal or high fan
speed. The light will illuminate when set to high
fan speed.
3