Switching Off - BLACK&DECKER XTW1500E Manual Del Usuario

Using the template guide (fig. D)
The template guide can be used to make a cutout shape from
a template, for instance a letter.
Secure the template over the workpiece with double-
N
sided tape or 'G' clamps.
The router bit must extend below the flange of the
N
template guide, to cut the workpiece in the shape of the
template.
Using the distance piece (fig. E)
The distance piece can be used for trimming wooden or
laminate vertical projections.
Using the centring pin (fig. F)
The centring pin can be used to cut out circular patterns.
Drill a hole for the point of the centring pin in the centre
N
of the circle to be cut.
Place the router on the workpiece with the point of the
N
centring pin in the drilled hole.
Adjust the radius of the circle with the bars of the edge
N
guide.
The router can now be moved over the workpiece to cut
N
out the circle.
Using the copy follower (fig. G)
The copy follower helps to maintain an equal cutting distance
along the edge of irregularly shaped workpieces.
Place the router on the workpiece at the desired distance
N
from the edge to be copied.
Adjust the bars of the edge guide until the wheel is in
N
contact with the workpiece.
Switching on and off
Switching on
Keep the lock-off button (2) depressed and press the
N
on/off switch (1).
Release the lock-off button.
N

Switching off

Release the on/off switch.
N
Warning! Always operate the tool with both hands.
Routing
Fit the router bit and adjust to the required depth of cut as
N
described above.
Holding the tool firmly with both hands by the handles (3),
N
place the tool on the workpiece and switch on.
Allow the tool to build up speed before plunging down
N
into the workpiece. When the depth stop bar has been
contacted, operate the plunge lock lever (5).
Carry out the operation by applying a constant force both
N
downwards and in the direction of cut. Retain a firm grip
on the handles and be prepared for a possible reaction
force if the router bit suddenly stalls e.g. following
contact with a knot.
On completion of the operation, release the plunge lock
N
lever and control the upwards movement of the tool back
to its original position. When the tool has returned to its
original position, it can be switched off. Be aware that the
base is springloaded and that the tool will jump upwards
if not controlled.
Routing speed
The operating speed of the tool can be varied to affect the
level of finish. The correct speed selection will depend upon
the level of finish required, the type of material being
machined, the diameter and shape of the router bit.
Prepare the tool to make a practice cut on a piece of scrap
N
material. Make a preliminary adjustment of the speed
control selecting a high speed for small diameter router
bits and a low speed for large diameter router bits.
When the routing operation is completed, withdraw the
N
tool from the workpiece, switch off and the tool inspect
the level of finish. Adjust the speed control knob (4) and
repeat until an optimum level of finish is obtained.
Warning! Do not release the handles to adjust the speed
when the tool is locked down and operating in the workpiece.
Hints for optimum use
When working on outside edges, move the tool
N
counterclockwise (fig. N). When working on inside edges,
move the tool clockwise.
Use HSS router bits for softwood.
N
Use TCT router bits for hardwood.
N
You can use the tool without a guide (fig. O). This is
N
useful for signwriting and creative work. Only make
shallow cuts.
Refer to the table below for common types of router bits.
N
ENGLISH
9