Replacement parts
Replacement parts are available at your dealer or Service Center.
Replacement parts for
ES‑LF71
Oil
Detergent cartridge
Cleaning the self‑cleaning recharger
Beard trimmings may become attached to the cleaning tray of the
self‑cleaning recharger. Follow the steps below to remove them.
We recommend doing this each time you change the detergent
cartridge.
1. Be sure to remove the water tank and the
appliance plug from the self‑cleaning
recharger.
•
Be careful not to spill the cleaning liquid.
. Gently wipe off any beard trimmings
attached to the inside of the cleaning tray
with a cloth or tissue paper dampened with
water.
•
Clean the corners and uneven parts of the
cleaning tray with a cotton swab
dampened with water.
ES-LF71_EU.indb
11
System outer foil and inner
WES907
blades
System outer foil
WES9167
Inner blades
WES906
WES00
WES05
Do not pull hard on the rubber blade protector (a) at the bottom
of the cleaning tray. The rubber may come off if you pull hard on
it. It is only necessary to pull it up slightly.
Warning
Do not wash or apply water to the AC adaptor or self‑
cleaning recharger. Failure to observe this may cause
electric shock or result in short circuits.
When the water does not drain from the cleaning tray
Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
Push the beard trimmings down through the
drain with a toothpick etc.
Removing the built‑in rechargeable battery
Remove the built‑in rechargeable battery before disposing of the
shaver. Please make sure that the battery is disposed of at an
officially designated location if there is one. Do not dismantle or
replace the battery so that you can use the shaver again. This
could cause fire or an electric shock.
Please contact an authorised service center.
•
Disconnect the power cord from the shaver when removing the
battery.
11
2011/03/03
11:44:30