Tabla de contenido
Publicidad
Note: Buckle of belts should be positioned centered on top of TV as shown on step 6 of page 3.
With TV dismounted from tray, place belt with buckle (C) centered on top of TV. Trace belt (C) along top and one side
to bottom edge of TV, and mark length.
Feed end of belt with buckle (C) through one steel belt loop (F) as shown. Position steel belt loop (F) so that it is
about 2 inches above marked length. Trim end of belt (C) about 6" from steel belt loop (F).
Note: To prevent fraying lightly burn trimmed end of belt (C).
Feed one end of belt without buckle (E) through one steel belt loop (C) as shown below. Leave 6 inches of belt beyond
the loop.
C
F
Note: There are 3 belt positions (pairs of slots) on the tray (the inner slots are not used). For the following steps choose the
slot that will place the belt firmly on the flat part of the top of your TV (most often this will be the front slot, see illustration,
step 6).
Remove backing and attach one
clear adhesive strip (A) through slot
and around edge of tray as pictured.
Repeat for other slot in other side of
tray.
Note: This material prevents fraying
or cutting of the belt.
Visit the Peerless Web Site at www.peerlessindustries.com
A
6"
C
Take one belt (C or E) and hold it so that the steel loop (F) is facing
as illustrated. Feed belt (C or E) up through the slot you have
chosen. Remember, belt only goes through outside slot. Now feed
belt (C or E) through steel loop (F) as shown. Repeat on other side of
tray using other belt.
F
C or E
2 of 7
ISSUED: 10-22-99 SHEET #: 120-9004-4 09-07-04
For customer service call 1-800-729-0307 or 708-865-8870.
Mark should be 2
inches from steel
F
belt loop.
Publicidad
Tabla de contenido
