Tabla de contenido
Publicidad
Locate the belt that does not have a buckle (E). Attach belt buckle (D) by feeding belt (E) through buckle as shown
(up through left slot, over center bar, and down through right slot).
D
Place TV onto tray.
Note: Be sure that front bottom edge of
TV is positioned behind and against the
front lip of the tray. This will prevent TV
from sliding forward on the tray.
Visit the Peerless Web Site at www.peerlessindustries.com
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
E
Note: Although it is rare, some TV's have a base deeper than the TV mount
support tray. If the base of your TV (not the total depth only the part that would
touch the tray) sits too far back to be supported by the tray, you will need to
purchase accessory kit ACC 130 or ACC 130W. This kit (as shown) will allow
the full depth of your TV to be safely supported. You can order it directly from
Peerless at 800-729-0307.
W
PM 20 TV Wall Mount with Tray Extension Kit accessory
Join both parts of belt on top of TV. Tighten, by pulling on the
loose end of the belt (E), just enough to remove slack.
Without removing adhesive backing, place one belt guide (B)
around belt (C) on the top left and one around belt (E) on top
right of the TV. Twist belt guides (B) enough to access the
adhesive backing and remove it. Once removed, press down
firmly on TV top. Tighten belt (E) securely by pulling on the
loose end. Then, trim loose end of belt (E) to leave about 8"
of the belt or as needed.
Note: To prevent fraying lightly burn trimmed end of belt.
B
C
3 of 7
ISSUED: 10-22-99 SHEET #: 120-9004-4 09-07-04
For customer service call 1-800-729-0307 or 708-865-8870.
E
B
Publicidad
Tabla de contenido
