Installing Adapter Brackets - PEERLESS SGLS01 Manual De Instalación

Installing Adapter Brackets

Refer to Screen Compatibility Chart to determine the proper fasteners to use.
13
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be attached.
Place adapter brackets (G) on back of screen, align to holes, and center on back of screen as shown in figure 13.1.
Attach the adapter brackets to the back of the screen using the appropriate combination of screws, multi-washers,
and spacers as shown in figure 13.3.
Note: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
WARNING
• Tighten screws so adapter brackets are firmly
attached. Do not tighten with excessive force.
Overtightening can cause stress damage to
screws, greatly reducing their holding power and
possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.)
maximum torque.
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers and spacers may not be
used, depending upon the type of screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown in figure 13.2.
WARNING
• If screws don't get three complete turns in the screen
inserts or if screws bottom out and bracket is still not
tightly secured, damage may occur to screen or
product may fail.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
fig. 13.2
MULTI-WASHER
CENTER BRACKETS
VERTICALLY ON BACK OF
SCREEN
G
fig 13.1
fig 13.3
8 of 30 ISSUED: 07-28-06 SHEET #: 202-9156-4 11-20-06
Note: "X" dimensions should be equal.
G
X
X
SCREWS
MULTI-
WASHER
SPACERS