Rola 59855 Manual Del Usuario

Part Description
A Button head bolts M5 x 30mm
B Nylon washer
C Washer-M5
D Hex nut- locking
E Screw end protector cap
F Hex key- 3mm
G Silicone sealant
H Track End Cap- open (Rear)
I Track End Cap- closed (Front)
J Track and Isolator pad
Tools required to install
A
D
E
B
C
Precaution Warnings before beginning
Use of ROLA track systems with bolts is intended for
fiberglass top installations.
Install requires drilling and permanent installation of
tracks.
Installation requires some tools and skill. If concerned
please have professionally installed.
Placement of Track Rails onto Vehicle surface (truck shell shown)
Align Tracks parallel to each other and equal
distance from rear.
Hint: pre-installing your ROLA cross bars on the
tracks will insure good placement.
59855N Rev A 2-11-13
Track Rail System
For use on fiberglass caps
Use with ROLA APE and APX cross bar kits
A
B
C
D D
G
H
F
Printed in China
Qty
12
12
12
12
A
12
B
1
C
1
D
2
2
2
Tools required:
Masking tape
Tape measure
8mm wrench
Fine tip marker Fine tip marker
Caution- never exceed the load rating for your
vehicle (contact manufacturer for details), or that
of your cross bar system which ever is lower.
Using a fine tip marker mark every other hole. Insure to mark the
holes on each end of the tracks.
Hint: Use masking tape to hold the tracks well in place while
marking. Isolator pad can be removed while marking.
PART No.
Carrying Capacity
G
E
H
F
I
J
E Drill motor
F Safety glasses
G
1/8" Drill bit
H H 1/4" Drill bit 1/4" Drill bit
CAUTION
59855
50 kgs
110 lbs
Page 1 of 2