Installation - Progress PDP6010E Manual De Instrucciones

INSTALLATION

Drilling the Support surface and Fitting
the Hood
SCREW FITTING
• The hood support surface must be 135
mm above the bottom surface of the wall
units.
• Drill the support with a ø 4,5 mm drill bit,
using the drilling template provided.
• Cut a hole ø 125 mm in size on the sup-
port surface, using the drilling template
provided.
• Fix using the 4 screws 12a (4,2 x 44,4)
provided.
SNAP-ON FITTING
• The hood can be installed either directly
on the bottom surface of the wall units us-
ing snap-on side supports.
• Cut a fitted opening in the bottom surface
of the wall unit, as shown.
• Insert the hood until the side supports
snap into place.
• Lock in position by tightening the screws
Vf from underneath the hood.
CLOSING ELEMENT
• The space between the edge of the hood
and the rear wall can be closed by apply-
ing the element 20 provided, using the
screws supplied for this purpose.
progress
���
��� ���
���
��
��
��
37