Setup; Osd Language; Tv System - Zinwell ZAT-970A Manual Del Usuario

1. Auto Scan
When you enter"Auto Scan＂menu, you see two sub
items: Scan Band and Search.
In Search Band item, presss ENTER to start scanning.
In the Auto Scan menu, press EXIT to draw back from
the scanning.
2. Manual Scan
There are two modes to scan channel: By Channel and
By Frequency.
The range of Channel Number is from 2 to 69 for ATSC.
In"Channel Number＂item, after press
channel number, the indicator below will show the signal
intensity and quality on this setting.
In "Frequency＂item, use
then press
to change the digit. Press ENTER set the
frequency value.
When you complete the modification, move highlight to
"Search＂item and press ENTER to start scanning.
The receiver scans channels and searches digital
signals.
Press EXIT to exit the scanning.

Setup

1. OSD Language

On the Setup menu, press
Language and press ENTER to confirm.
Press to select the language used for OSD: English,
Español, Français.
Press EXIT button to draw back from OSD Language
menu.

2. TV System

On the Setup menu, press
System and press ENTER to confirm.
Aspect Ratio is used for switching the screen aspect
ratio mode. Now we provide below options:
4:3LB/4:3PS/16:9. Press
circularly. You can also press the ZOOM button on the
remote control to switch each mode directly.
Press to highlight the RF Output, and then press
to set channel selection to either RF CH3 or RF CH4.
The default RF Output is RF CH-3.
If your STB is ZAT-970A and you want to receive analog
TV channels on your TV, you need to switch current the
RF Output from the RF CH-3/CH-4 to the RF Through.
Press to highlight the RF Output, and then press
to set channel selection to RF Through.
Press to highlight the Audio Mode, and then press
to select RF Mode and Line Mode.
to select a
to highlight any digit,
to highlight the OSD
to highlight the TV
to select each mode
6
6