Forno DSP-IND-1CG-DCL-30 Manual Del Usuario página 13

V. Cleaning and Maintenance:
Cleaning Burned on Residue:
WARNING: Damage to the glass surface may occur if you use scrub pads or any
other type of abrasive cleaning materials.
1. Allow the cooktop to cool.
2. Spread a few drops of the ceramic cooktop cleaner on the burned residue area.
Using the included ceramic cooktop cleaning pad, rub the residue area,
3.
applying pressure as needed.
4. If any residue remains,repeat the steps listed above.
5. For additonal protection,after all residue has been removed,polish the
entire surface with the ceramic cooktop cleaner and a paper towel.
Cleaning heavy burned - on residue:
1. Allow the cooktop to cool.
2. Used a single -
against the glass surface,and scrape o the residue.
After scraping off the residue,apply a few drops of the ceramic cooktop cleaning
3.
solution on the entire burned residue area.Use the cleaning pad to remove any
remaining residue.
For additonal protection,after all residue has been removed,polish the entire
4.
surface with the ceramic cooktop cleaner and a paper towel.
Metal Marks and Scratches:
Be careful not to slide pots or pans across the cooktop surface. It will leave behind
metal markings. These marks are removable using the ceramic cooktop cleaner
along with the cleaning pad for ceramic cooktops
.
If pots with a thin overlay of aluminum or copper boil dry,the overlay may leave a
black discoloration on the cooktop.This should be removed immediately before
using the cooktop again or the discoloration will become permanent.
. NOTE: If cracks or indentations in the glass surface occurs,the cooktop glass
will have to be replaced.Contact the manufacturer for assistance.
edge razor blade scraper approximately at a 45 degree angle
ff
11