Forno DSP-IND-1CG-DCL-30 Manual Del Usuario página 19

If the display shows an error code,please refer to this sheet for a potential solution.
Error Code
appears on the
" " E
Power display
" E0 appears in the "
Timer display
appears in the
" E1 "
Timer display
appears in the
" E2 "
Timer display
" E3 " appears in the
Timer display
" E7 " appears in the
Timer display
appears in the
" E8 "
Timer display
" E9 "
appears in the
Timer display
" EE " appears in the
Timer display
VII.Troubleshooting Error Codes
Possible Cause
Electronics fault error
message of specific cooking
zone.
I G B T o v e r h e a t i n g .
No cookware found or improper
placement of cookware on the
cooking zone.
Supplied voltage to cooktop
is too low.
Supplied voltage to cooktop
is too high.
NTC1 break of
NTC1 short circuit
NTC2 break of
NTC2 short circuit
See E0,E1,E2,E3,E7,E8,E9,EE
Turn of unit untl to allow IGBT to
cool.Restart until.
Make sure the cookware is centered on the
cooking zone,and that it's also induction
compatible.See Compatible Cookware.
If the voltage of the power supply to the
cooktop is too low,it cannot operate
properly and will show this error code.
This may be caused by reduced voltage being
supplied to the house circuit. If the connections
are correct and supplied voltage returns to
normal, the code will disappear.
If the voltage of the power supply to the
cooktop is too high,it cannot operate
properly and wil show this error code.
This may be caused by increased
voltage being supplied to the house
circuit.If the connections are correct
and the supplied voltage returns to
normal,the code will disappear.
Turn OFF the cooktop;then shut of the
power at the fuse or circuit breaker for
about 30 seconds.Turn the power back
on to the cooktop then press the
POWER button to turn on the unit.If the
error message is still being
displayed,call for service.
17
Solution