Technical Data; Special Safety Instructions - Probuilder 32891 Manual De Instrucciones

MITRE SAW WITH TELESCOPIC EXTENSION
Introduction
To get the most out of your new mitre saw
with telescopic extension, please read these
instructions before use. Please also save the
instructions in case you need to refer to them
at a later date.

Technical data

Voltage/frequency:
Power rating:
Speed:
Saw blade:
Hole diameter:
Max. cutting capacity:
0° × 90°:
0° × 45°:
45° × 45°:
45° × 90°:
Sound pressure, L :
PA
Sound level, L : Sound level, L Sound level, L
WA WA
Accessories supplied: 2 pull-out rails, clamp,
dust bag and spanner
Easy transport with carrying handle
40
220-240 V ~ 50 Hz
2,000 W
4,500 rpm
Ø 255×2,8 mm, 36 T
30 mm
340 mm x 90 mm
340 mm x 45 mm
240 mm x 90 mm
240 mm x 45 mm
97.2 dB(A), K=3 dB(A)
110.2 dB(A), K=3 dB(A)

Special safety instructions

Check that the motor's vent holes are not
blocked.
Never stop the saw blade by pressing against
the saw, or by applying pressure to the side
of the saw blade.
Always use the correct type of saw blade
for the job at hand. This saw is designed for
sawing wood. Never use bent saw blades or
saw blades that have teeth missing.
Never use saw blades that are too large or
too small.
Never use saw blades whose maximum
speed is less than the saw's maximum RPM.
Check that the direction indicated on the
saw blade matches the direction of rotation
of the motor. The saw blade teeth must point
downwards towards the saw bench on the
front of the saw.
Always wear protective gloves when
handling the blade. Never put your hand
under the mitre saw or try to remove
material from the working area while the
blade is rotating.
Never place your � ngers or hand on the item
being cut in front of, behind or under the
mitre saw while it is running.
Never saw more than one item at a time.
Use extra supports (table, trestle or similar)
for long items so they do not tip off the
workbench during sawing.
Do not saw items that are so small they
cannot be securely clamped.