Temperature Cut-Out; Volumetric Flow Monitoring; Working - Festool CLEANTEX CTM 26 E Manual De Instrucciones Original/Lista De Piezas De Repuesto

7.5 Applying the brake
Folding out the black brake lever
vents the mobile dust extractor from rolling. To
achieve this, lift the front end of the mobile dust
extractor slightly and push the black brake le-
ver downwards until it latches into place. Push
the green lever [1-14]
7.6

Temperature cut-out

To prevent overheating, a temperature cut-out
switches the mobile dust extractor off when it
reaches a critical temperature.
Switch off the mobile dust extractor and al-
low to cool for about 5 minutes.
If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
7.7 Changing the filter bag
Removing the filter bag
Open the locking clips
top section of the machine[2-1].
Remove the filter bag.
Dispose of the used filter bag in accordance
with statutory regulations.
Clean the dust container [2-3].
Inserting the filter bag
Insert a new filter bag (FIS-CT 26/36) in the
inlet port of the dust container and interlock
it. Important: be aware that the locking
engages.
7.9

Volumetric flow monitoring

An acoustic warning signal sounds if the air speed in the suction hose falls below 20 m/s.
Possible causes
Value set on the suction power adjuster
10] is too low.
Rotary knob [1-9] not set to the correct
hose diameter.
Suction hose blocked or kinked.
Filter bag full.
Filter element clogged.
Monitoring electronics malfunction.
Wet extraction.
8

Working

8.1 Handling
Hose store: after finishing work, you can feed
[1-15] pre-
again to release.
[4]
[2-2] and remove the
[5]
[1-
CTM/ CTM AC CLEANTEX
Replace the top section
locking clips [2-2].
Make sure that the filter bag is not pinched
between the top and bottom sections.
7.8 Changing the disposal bag
Removing the disposal bag
Close off the extractor opening
the sealing plug [1-1].
Open the locking clips
top section of the machine[2-1].
Close the disposal bag.
Remove the disposal bag.
Dispose of the used disposal bag in accor-
dance with statutory regulations.
Clean the dust container [2-3].
Inserting the disposal bag
Insert a new disposal bag (ENS-CT26/36)
on the inlet nozzle of the container and lock
in position.
Important: The lateral openings on the dis-
posal bag must be positioned inside the con-
tainer. Make sure that the bolt engages.
Place the disposal bag over the edge of the
container.
Make sure that the contacts are free.
2]
Replace the top section
locking clips [2-2].
Solution
Set the suction power adjuster to a higher
value (see Chapter 7.4).
Set the knob to the correct hose diameter (see
Chapter 7.1).
Remove blockage or kink.
Insert a new filter bag (see Chapter 7.7).
Change the filter element (see Chapter 9.1).
Only AUTOClean: Clean filter element (see
chapter 8.2).
Send to a Festool service workshop for repair.
Functional reliability not affected, no actions
required.
the suction hose through the recess
place it in the hose store. You can do the same
with the mains cable through the other recess
[8-2].
GB
[2-1] and close the
[6]
[1-2] using
[2-2] and remove the
[7]
[10-
[2-1] and close the
[8-3] and
17