Glass Shelves; Odor Removal; Light Bulbs Replacement - Amana BC20TL Manual Del Usuario

4. Raise stabilizing legs (some models) by turning
counterclockwise.
CAUTION
Protect soft vinyl or other flooring with cardboard, rugs
or other protective material to avoid property damage.
5. Pull refrigerator away from wall. Run a vacuum
brush across grille on back of refrigerator.

Glass Shelves

CAUTION
Handle tempered glass shelves carefully to avoid
personal injury or property damage. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
Remove shelf by lifting front, releasing hooks from metal
track then pulling out. Place shelf on a towel. Allow shelf
to adjust to room temperature before cleaning.
Clean crevices by completing the following:
1. Dilute mild detergent and brush solution into crevices
using a plastic bristle brush. Let sit for 5 minutes.
2. Spray warm water into crevices using faucet spray
attachment.
3. Dry shelf thoroughly and replace shelf by inserting
hooks into metal track and lowering it from the front.

Odor Removal

1. Remove all food and disconnect power to refrigerator.
2. Clean all interior surfaces including ceiling, floor, and
walls according to General Cleaning instructions
above. Pay special attention to corners, crevices, and
grooves. Include all drawers, shelves, and gaskets.
3. Connect power to refrigerator and return food to
refrigerator. Wash and dry all containers. Wrap foods
in tightly sealed containers to prevent further odor.
After 24 hours, check if odor has been eliminated.
Complete steps 4-9 if odor has not been eliminated.
4. Place crispers on top shelf of refrigerator section.
Pack refrigerator and freezer sections, including
doors, with crumpled sheets of newspaper.
5. Place charcoal briquettes randomly throughout
newspaper.
6. Close doors and let stand 24–48 hours.
7. Remove charcoal briquettes and newspapers.
8. Complete steps 2–3.
If odor is still not eliminated, contact consumer affairs
department. Refer to Model Identification section for
phone number.

Light Bulbs Replacement

Disconnect power to refrigerator before replacing light
bulb to avoid electrical shock which can cause severe
personal injury or death. After replacing light bulb,
restore power.
Observe the following to avoid personal injury or
property damage.
• Allow light bulbs to cool
• Wear gloves when replacing light bulb.
• Remove light bulb cover by removing ¼" hex nut
screws. Replace bulb(s) with 40-watt appliance bulb(s).
• Replace light bulb cover by replacing ¼" hex nut
screws.
15
WARNING
CAUTION
1/4" hex
nut screws
Light bulb
cover