Ryobi RY43161 Manual Del Operador página 10

THREADED
BASE
RUBBER
CORD
PROTECTOR
CONNECTING THE POLES
See Figure 3.
Before using the pole saw, a one-time assembly is
required. When removed from the box, the three
poles are connected by an electrical cord as shown
above.
 Remove the four (4) rubber cord protectors
from inside the poles. This material protects the
cord during shipping and MUST be discarded
immediately.
 Unscrew the lower collar from the threaded base
on the intermediate pole and push back over the
cord to the handle pole shaft as shown.
 Align the button on the handle pole with the
pin hole on the intermediate pole. Insert the
handle pole into the intermediate pole and slide
together until you hear the button click.
ASSEMBLY
HANDLE
POLE
BUTTON
CORD
UPPER
COLLAR
Page 10 — English
RUBBER CORD
PROTECTOR
LOWER
COLLAR
PIN HOLE
INTERMEDIATE
POLE
POWERHEAD
POLE
 Lower the collar on the handle pole to the
threaded base on the intermediate pole and
rotate clockwise to secure.
 Repeat this process to attach the intermediate
pole to the powerhead pole.
NOTE: Once assembled correctly, handle pole and
powerhead pole should not be able to separate
from intermediate pole when pulled. Repeat above
steps if poles can be separated from intermediate
pole.
WARNING:
Failure to lock powerhead pole as directed
above could result in serious injury or death.
BUTTON
THREADED
BASE
Fig. 3