Mode
6
7
8
released there is a 1 second
second. If button is pressed
Step
Reset the Collar Receiver
6
To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a
new Collar Receiver to work with your existing Remote Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off after 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin fl ashing as normal. If this occurs, start over and repeat the
process.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1m from each
other before this occurs. Once the Receiver Indicator Light has fl ashed 5 times, the
Collar Receiver has been reset and will begin fl ashing as normal. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat the process.
UPPER BUTTON
FUNCTION
DOG #1
Audible Tone for 1 second,
then Low Continuous
Stimulation without
Audible Tone. Low
Stimulation level set by
Dial.
DOG #1
Continuous Stimulation
without Audible Tone.
Stimulation level set by
Dial.
DOG #1
Continuous Stimulation
without Audible Tone.
Stimulation level set by
Dial. When the button is
delay followed by an
Audible Tone lasting for 1
again before 1 second
delay, the Audible Tone is
not delivered.
LOWER BUTTON
FUNCTION
DOG #2
Audible Tone for
1 second, then
Low Continuous
Stimulation without
Audible Tone. Low
stimulation level set
by Dial.
DOG #2
Continuous
Stimulation without
Audible Tone.
Stimulation level set
by Dial.
DOG #2
Continuous
Stimulation without
Audible Tone.
Stimulation level set by
Dial. When the button
is released there is a 1
second delay followed
by an Audible Tone
lasting for 1 second. If
button is pressed again
before 1 second delay,
the Audible Tone is not
delivered.
www.sportdog.com
SIDE BUTTON
FUNCTION
DOG #3
Audible Tone for
1 second, then
Low Continuous
Stimulation without
Audible Tone. Low
stimulation level set
by Dial.
DOG #3
Continuous
Stimulation without
Audible Tone.
Stimulation level set
by Dial.
DOG #3
Continuous
Stimulation without
Audible Tone.
Stimulation level set
by Dial. When the
button is released
there is a 1 second
delay followed by an
Audible Tone lasting
for 1 second. If button
is pressed again before
1 second delay, the
Audible Tone is not
delivered.
# OF
DOGS
3
3
3
11