Simplicity Conquest Serie Manual Del Operador página 18

OPERATION
Mowing in Reverse (RMO)
If an operator chooses to mow in reverse, the RMO sys-
tem can be used. To use the Reverse Mowing Option
(RMO) turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then mow
in reverse. Each time the PTO is engaged the RMO needs
to be reactivated if desired. The key should be removed to
restrict access to the RMO feature.
Attachment Operation in Reverse
If an operator chooses to operate a PTO driven attach-
ment in reverse, the RMO system can be used. To use
the Reverse Mowing Option (RMO) turn the RMO key
after the PTO is engaged. The L.E.D. light will illuminate,
and the operator can then operate the attachment in re-
verse. Each time the PTO is disengaged the RMO needs
to be reactivated if desired. The key should be removed to
restrict access to the RMO feature.
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Push the lever approximately 2-3/8" (6 cm) to release
the transmission (B, Figure 5).
3. The tractor can now be pushed by hand.
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age.
• Do not use another vehicle to push or pull
this unit.
• Do not actuate the transmission release
valve lever while the engine is running.
18
Adjusting Mower Cutting Height
The height-of-cut switch (A, Figure 6) adjusts the mower
cutting height. Press the switch UP to raise the mower
cutting height and DOWN to lower the mower cutting
height. The cutting height is infinitely adjustable between
1.5" and 4.0" (3,8 and 10,2 cm).
Attachment Lift Control
The attachment lift lever (B, Figure 6) raises and lowers
attachments that utilize the tractors manual lift linkage. To
lower an attachment: pull the lever back slightly, depress
the release button, and push the lever forward until it
locks in the lowered position. To raise an attachment: push
the lever forward slightly, depress the release button, then
pull the lever back until it locks in the raised position.
Attaching a Trailer
The maximum horizontal drawbar force allowed is 444
Newton. The maximum vertical drawbar force is 222 New-
ton. This equates to a 396 lbs (180 kg) trailer on a 10 de-
gree hill. Secure the trailer with an appropriately sized
clevis pin (A, Figure 7) and clip (B).
Stopping the Tractor and Engine
WARNING
Fuel and its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns or
death.
• Do not choke the carburetor to stop engine.
1. Move the throttle control to the SLOW position. Turn
the key switch to the OFF position. Remove the key
and keep in a safe place out of the reach of children.
2. After the engine stops, turn the fuel shut-off valve, if
equipped, to the closed position.
www.simplicitymfg.com