Signal Connections; Speaker Connections - DB Drive DBA Serie Manual De Instrucciones

S
IGNAL CONNECTIONS
Connect the RCA output of the head unit (AM/FM cassette player, CD, or DAT) to the RCA
input terminals of the amplifier.
To make these connections, we recommend high quality RCA cables, which are available
at your local car audio retailer. Run signal wires away from electrical wires to avoid possibil-
ity of induced noise from the car's electrical system (i.e. popping noises or engine noise).
MONO SIGNAL
CONNECTION
SIGNAL CONNECTION:
4 Channel Amplifier using
2 pair of RCA inputs.
Optional full range line out connection
L R
to addition addition in the system.
94.7
Optional full range line out connection
to addition addition in the system.
L R L R
94.7
7
S
PEAKER CONNECTIONS
IMPORTANT! The following speaker connection are for the amplifier in normal mono
configuration.
Make the speaker connections using speaker wire that is at least 16 gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential for
strong bass response. When connecting, make sure that positive (+) from the amplifier is
connected to the positive (+) of the speaker, and the same for negative (-).
Please note that although the the DBA1600.1D are mono amplifiers, we have provided two
sets of speaker terminals on the amplifier. These terminals are connected in paralleled
internally (connected together). The second set of speaker terminals are intended for ease
of connection when running multiple woofers.
2 Ohm Speaker (1 Ohm minimum)
+ -
4 Ohm Speaker
(1Ohm minimum)
+ -
4 Ohm Speaker
+ -
4 Ohm Speaker
8