Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
T
ROUBLE SHOOTING THE SYSTEM
We have put together this trouble-shooting guide if you experience problems after
installing the amplifier. Please keep in mind that the majority of problems incurred are
caused by improper installation and not the equipment itself. In addition, there are many
components in the system that could cause various signal problems such as inducted
electrical noise and engine noise.
Before you can properly address the problem, you must first find the component that is
causing the problem. This will take patience and a process of elimination.
LOOK FOR.....
No Output
Blown fuse
Bad RCA Cable(s)
+12V at power terminal
+12V at remote terminal
Grounding point clean and tight
Head Unit's fader not in center position
Master & Slave settings
Low Output
Check level adjustments
Re-adjust
Bad RCA cable(s)
Improper level matching
Master & Slave settings
Engine Noise
Grounding points are clean and tight
Ground all components at same point
Try different grounding point
Bad RCA cable(s)
Use High Quality shielded RCA cables
Low Vehicle charging system and/or battery Fix and/or replace
Red Protection L.E.D. illuminated
Speaker short
Speaker grounding out
Impedance too low
Overheating
SOLUTION
Replace
Replace
Check connection
Check connection
Check for ground w/meter
Set to center position
Confirm correct setting
Replace
Re-adjust
Confirm correct setting
Check for ground w/meter
Ground at same point
Change for better ground
Replace
Rejects inducted noise
Check speakers connection
for short circuit
Make sure speaker wires
Do not touch chassis ground
Check speaker impedance
Check mounting location
for Adequate air circulation
speaker impedance too low
13
S
PECIFICATIONS
Input Voltage @ 11 - 14.4 VDC:
@ 4 ohm
2 x 300 watts
@ 4 ohms Bridged
2 x 150 watts
@ 2 ohm
Frequency Resp.
S/N Ratio (A-weight)
220mV. - 5.0 V
Low Input Level
Crossover Type
125Hz - 3.3KHz
Crossover Freq. (Lowpass)
Crossover Slope
6 - 12 dB @ 45Hz
Bass EQ.
Fuse Rating
Remote Bass
Input Voltage @ 11 - 14.4 VDC:
DBA1600.1D
@ 4 ohm
1 x 400 watts
@ 2 ohm
1 x 800 watts
@ 1 ohm
1 x 1600 watts
Frequency Resp.
20Hz - 250Hz
S/N Ratio (A-weight)
Low Input Level
200mV - 4.7V
Crossover Type
Crossover Freq. (Lowpass)
40Hz - 150Hz
Crossover Slope
Bass EQ.
0 - 12dB @ 45Hz
Subsonic Filter
Remote Control Included
Fuse Rating
Due to continuous improvement of the product the Specifications are subject to change without notice.
DBA80.4
4 x 80 watts
10Hz-20Khz
>98dB
Hi/Low Pass
12db per oct
2 x 20 amp
n/a
>90dB
Low Pass
12dB per oct
20Hz - 50Hz
optional
4 x 20 amp
14
Publicidad
Tabla de contenido
