Fitting The Harness - Stihl FS Manual De Instrucciones

English
WARNING
Direction of rotation is indicated by an
arrow on the inside of the deflector.
14
13
11
10
12
Place the cutting attachment (8) on
N
the thrust plate (9).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
Fit the thrust washer (10) – convex
N
side must face up.
Fit the rider plate (11).
N
Block the shaft (12).
N
Use the combination wrench (14) to
N
screw the mounting nut (13) on to
the output shaft counterclockwise
and tighten it down firmly.
52
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
8
Block the shaft.
N
9
Unscrew the mounting nut
N
clockwise.
Remove cutting attachment and its
N
mounting hardware from the
gearbox – but do not remove the
thrust plate (9).

Fitting the Harness

Not all basic power tools are equipped
with a harness and carrying ring.
To retrofit the carrying ring – see
N
"Mounting the Attachment"/"Fitting
the Carrying Ring".
The shoulder strap/harness is available
as a special accessory.
The type of carrying ring, shoulder
strap/harness and carabiner depends
on the market and the basic power tool.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
FS