Technical Specification; Preparations - Carson marines HM-38 Manual De Instrucciones

Identification for GA-005
1. Plug in a 15 - 18 V/ 1000 mA DC power at the input jack
(notice the polarity). The status LED is lighting in red.
2. When charging a 7.4 V Li-ion or Li-polymer battery pack,
plug the pin of your battery into the 2 CELL jack of your
GA-005 in a certain direction. Then the charging LED will
become red and flashing, and this means the battery has
entered charging status. When your battery is fully charged,
the LED will become green.
3. When charging a 11.1 V Li-ion or Li-polymer battery pack,
plug the pin of your battery into the 3 CELL jack of your
GA-005 in a certain direction. Then the charging LED will
become red and flashing, and this means the battery has
entered charging status. When your battery is fully charged,
the LED will become green.

Technical Specification

Output current: 750 mA
Input voltage: DC 15 - 18 V/ 1000 mA
Output Voltage:
2 cell DC 7.4 V Jack
8.4 V
j. Preparations
General remarks
• If you have no or little experience with airplane models, you
should first practice with a Flight simulation program.
• Seek advice from an experienced R/C user for the first few
attempts.
• Acquaint yourself with the control functions of the
transmitter.
• Begin your flight experiments standing behind the model,
the line of sight in the flight direction. In this case, the control
reaction is the same as the direction of control.
Furthermore acquaint yourself with the control of the model as
it comes towards you (side-inverted reaction to the direction of
control)!
3 cell DC 11.1 V Jack
12.6 V
CARSON Helikopter MARINES HM-38 50 050 7025
Notice:
Every time only one group of battery pack can be charged. It
is forbidden to charge two groups; otherwise your charger or
battery will be damaged or burnt.
When the LED flash twice and then don't light circularly, that
means the battery pack were broken.
Charging and installation of the airplane
batteries
Always charge the battery outside the model on a fire-proof
surface.
1. Connect the battery charger with the battery adapter.
2. Plug the plug battery charger in a power socket.
3. Put the battery in a metal bowl and connect the battery with
the battery charger.
4. Make sure that the connector is inserted correctly to avoid a
short circuit.
5. Do not cover the battery!
The temperature of the battery should not exceed 60 °C during
the charging process.
The charging process is finished when the green LED on the
balance charger lights up.
GB
17