Flybar Set Assembly; Flight Operation - Carson marines HM-38 Manual De Instrucciones

l. Flybar set assembly
GB
1. Let the location notch of the flybar block aim at the flybar,
and press the flybar block till the flybar reaches the end of
the notch; insert one end of the flybar through the hole 1.
2. Let the location notch of the flybar block aim at the inner
location mast of the flybar block sleeve, and press the flybar
block along the inner location mast into the sleeve.
3. Counterclockwise rotate 90° the flybar block sleeve, let the
hole 1 of the flybar block sleeve aim at the hook of the flybar,
and then push the flybar block set outside and make the
hook completely insert into hole 2.
Note:
The flybar set will be thrown off at high speed in flying when it
is mounted improperly. A serious damage to people or property
may be taken place.
m. Flight operation
Switching on the model
Ensure sufficient space in order to undertake the first flight
experiments. Even if the helicopter can later be flown in the
smallest quarters, it requires about 3m free space in all
directions.
• Set the model on a smooth and level surface, so that the
helicopter can freely glide and lift off.
• Set the helicopter about 2 m in front of yourself on the
ground, the tail pointing towards you. This way the direction
of reaction of the helicopter conforms to the direction of
control.
• Pull the left remote control lever (pitch) totally back
(also trim).
• Switch the transmitter on.
• The battery indicator starts to flash.
• Now connect the charged airplane battery to the receiver.
20 CARSON Helikopter MARINES HM-38 50 050 7025
Flybar block Flybar block sleeve
Flybar
Location notch
Flybar block sleeve
➀
➁
90°