American Standard Advanced Clean 100 Combo Manual Del Usuario página 47

Cleaning and Maintenance
The battery LED on the edge of remote flashes when the batteries are low. ( ☞ Page 25)
[CAUTION]
● Install batteries in the correct orientation of polarity
as illustrated on the remote control display.
● Do not use a mix of new and old batteries.
● Use alkaline batteries only.
● Be careful not to touch any switches on the remote
control when replacing batteries.
Replacing Remote Control Batteries
1 Lift the remote control out of the holder.
(Reference)
● The battery LED will flash when the batteries are low. This LED normally does not appear.
● The batteries supplied with the SpaLet are used for operation checks at the factory, and so have a shorter service
life than typically available batteries.
● Batteries may become fully discharged before the battery LED flashes depending on the size of the room and
material/color of the walls, particularly with darker colors.
● When replacing batteries, wait for the battery LED to disappear after the batteries have been removed before
inserting the new batteries. This is because the battery LED may remain flashing after batteries have been replaced.
2 Remove the back cover and replace with
Remote
Control
Holder
3 Reinstall the back cover and then use the
【Hr.】 and 【Min.】 buttons to adjust the time
4 Return the remote control into the holder.
two new 1.5-V AAA alkaline batteries.
* If the back cover is difficult to remove, use a flat-
blade screwdriver or similar tool to release the lock.
Back cover
Alkaline
batteries
( ☞ Page 10).
Battery LED
Lock
44 - EN