Honeywell HJ12CESV Serie Manual De Instrucciones página 16

USE AND OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
MODE CONTROL
Settings: Air Conditioning, Dehumidifying, Fan, Heating*.
The corresponding indicator light will illuminate to indicate the current mode setting.
• Air Conditioning Mode (COOL)
Adjust fan speed and air temperature to suit your desired comfort level.
Temperature setting range is 61°F - 88°F (16°C -31°C).
• Dehumidifying Mode (DRY)
Air is dehumidified as it passes through the unit, without being in full cooling mode.
The fan speed is preset as LOW speed and can NOT be adjusted.
Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose.
Continuous drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
IMPORTANT: The Dehumidifier Mode is used to support moisture reduction but should not
be expected to dehumidify to the same degree as a standard dehumidifier only appliance. The
built-in dehumidifier automatically adjusts dehumidification based on ambient room temperatures.
It is not possible to adjust to a desired humidity percentage. The front display only shows the
current and desired temperatures. It does not show humidity levels.
• Fan Mode
For air circulation without air conditioner cooling.
• Heating Mode*
When heating mode is selected the indicator light will shine. Heating is activated only when
the ambient temperature is below 77°F (25°C). In this mode, the desired temperature can be
set between 61°F - 88°F (16°C -31°C).
Note: The exhaust hoses must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the internal
water tank. The unit will pause operation when the tank is full and will restart when the tank has
been emptied. It is recommended to use the Heating Mode in a room with 50% humidity or lower.
Avoid operating moisture-producing products or appliances such as a humidifier or a kettle when
using the unit in Heating Mode. See the "Draining Water Condensation in Heat Mode" section for
more information on draining the water tank.
TIMER / TEMPERATURE SET CONTROLS
The and buttons can be used to adjust and set your desired temperature in Cooling or
Heating* modes. They can also be used to set the Timer (see "Timer Control" below).
*Applicable for models with Heating feature only.
EN 8