Technical Specifications - VONROC BG501AC Traducción Del Manual Original

tool. This rotary multi tool is great for editing of
materials like wood, plastic, stone, shell aluminium,
brass and steel. Always use the proper accessories
and speed setting.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
Rotational speed, not loaded
Duty time
Grinding wheel dimensions
Spindle hole diameter
Class
Weight
Lpa (Sound pressure level)
Lwa (Acoustic power)
Load factor
A load factor of S2 = 30 min (intermittent periodic
duty) means that you may operate the motor con-
tinuously at its nominal power level for no longer
than the time stipulated on the specifications label
(30 minutes ON period). If you fail to observe this
time limit the motor will overheat. During the OFF
period the motor will cool again to its starting
temperature.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
- Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
- The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
WWW.VONROC.COM
BG501AC
230V - 240V
50 Hz
150 W
0-9900 /min
S2 = 30 min
Ø 75x20 mm
Ø 10 mm
II
2.24 kg
75.8+3 dB(A)
88.8+3 db(A)
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. On/Off switch
2. Spark guard
3. Spark guard bracket
4. Safety guard
5. Grinding wheel
6. Polishing wheel
7. Tool rest adjustment knob
8. Tool rest
9. Mounting holes
10. Spark guard adjusting screw
11. Speed adjustment knob
12. Flexible shaft
13. Locking pin
14. Wrench
3. ASSEMBLY
The grinder must be firmly bolted to a workbench.
The length of the fixing bolts will depend on the
thickness of the workbench. If the workbench is
made of steel, it is advisable to use a wooden block
or plank between the grinder and the bench, to
insulate it and prevent vibration.
Assembly and adjustment of spark guard bracket
and spark guard (Fig. C & D)
The spark guard bracket and spark guard
should only ever be assembled/adjusted
with the grinding wheel stationary, and the
machine disconnected from the power
supply.
• Fix the spark guard bracket (3) to the grinding
wheel cover, using the screws provided (10).
• Set the spark guard bracket at the correct
height. The clearance between the wheel and
the spark guard bracket should be 1 to 1.5 mm.
• Next tighten the screws (10) firmly.
• Fix the spark guard (2) to the spark guard
bracket (3).
• Position the spark guard to give maximum
protection when working.
• Always wear safety glasses.
EN
7