Briteq BT-Dazzle Manual De Instrucciones página 11

ENGLISH
Reset
Used to force a reset of the unit.
 Press the MENU button until the display shows "Reset".
 Press the ENTER button to reset the unit.
Please also check the chapter about the DMX-channel configuration of the unit to find out how you can force
a reset by DMX.
OFFSET MENU:
Used to adjust the home position of
pan and tilt when the alignment of the
beams would be slightly different:
Make sure that the unit is connected to a
DMX-controller and set to the 14CH or
16CH channel mode
If you're not already in the setup menu,
just press the MENU button shortly to
enter the setup menu ("DMX Address" is
shown on the display)
 Now press the ENTER button for at
least 5 seconds to go into offset mode.
 Use DOWN and UP buttons to select the position you want to adjust
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to adjust the home position
 Press the ENTER button to select your setting.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Electrical installation for 1 standalone unit:
 Just insert the mains cable. The unit starts working immediately in stand-alone mode.
Remark1: You can connect a CA-8 or RF-8 remote controller to the unit if you want to have more control.
Refer to "how to operate the unit" to learn how to do this.
Remark2: if there's no output, please make sure to set the unit in master mode and set the blackout mode
to "NO" and Sound State to "On" (see previous chapter)
Electrical installation for two or more units in master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will automatically act as the master, the other units will act automatically as slaves.
 Make sure that all units are connected to the mains.
 Done!
Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control
over the master/slave operation
Remark2: if there's no output, please make sure to set the first unit in master mode and set the blackout
mode to "NO" and Sound State to "On". Another way to do this is to reset the unit to [Auto default] (see
previous chapter)
BRITEQ
®
9/80
OPERATION MANUAL
BT-DAZZLE