Bimar VT322 Folleto De Instrucciones página 7

 Do not pull on the cord to disconnect the plug from the socket.
 Do not allow children, or irresponsible persons, to use the device without supervision.
 If the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
 Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
 In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help.
 Ensure that the fan is switched off from the supply mains before removing the guard.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are unsure, do not use it and ask for qualified
professional help. The packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger. Attention: any stickers or advertising material applied to the grid removed
before using the appliance. The manufacturer declines all responsibility in case this is not safe working practices will be
respected.
 Before connecting the appliance, check that the voltage values shown on the data plate correspond to those of the
electricity supply network. In the event of incompatibility between the electric outlet and the plug of the appliance, have
the outlet replaced with another more suitable type by professionally qualified personnel, who will make sure that the
section of the wires of the outlet is appropriate for the absorbed power of the heater. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the heater.
 The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
 Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum distance of 2 meters) to avoid
the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air intake grille; make sure
that the front is free of unstable materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or wrapped around the
appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance could upset).
 Do not place the appliance near an open flame, cooking or other heating appliance.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power cord is damaged, it
must be replaced by the manufacturer or a competent qualified electrician or a person with similar qualifications, in order
to avoid any risk.
Attention: the fan can be used only when completely and correctly assembled, that is complete with its base and protection
grid.
Attention: always unplug the appliance before you assemble.
If in doubt, have the appliance checked or assembled by a qualified professional person. For assembly, refer to figure.
1) Front grille
2) Fan attachment ring nut
3) Grille attachment ring nut
4) Rear grille
5) Motor shaft
6) Oscillation button
7) Body
8) Base
9) Selector
10) Fan
11) Screws and nuts
fasten the grille
12) Screws
13) Handle
7/20
for