HOW TO BREW
Fig. 1
Fig. 4
Fig. 5
1
Place the brewer on a dry, clean, and
level surface. Plug your brewer in and
power it on.
2 Remove the water reservoir from the unit
by lifting it straight up (Fig. 1). Remove
the lid entirely and fill the water reservoir
to the desired level
(Fig. 2).
NOTE: DO NOT fill past the 12-Cup Line.
If overfilled, remove the water reservoir
from the brewer and pour out water until
the level is no higher than the
12-Cup Line.
3 Place a #4 paper cone filter or a
permanent filter (included with some
models) in the removable filter holder.
Fold the paper filter along the seams,
open it fully, and press it firmly into the
removable filter holder, making sure it
is fully seated.
7
Fig. 3
Fig. 2
Fig. 6
4 Place the filter holder into the brew
basket (Fig. 3). Then add desired
amount of coffee grounds.
5 Place the brew-through lid on the
carafe and turn clockwise to lock into
place (Fig. 4). Then place carafe under the
brew basket (Fig. 5).
6 Select either CLASSIC or RICH brew. If
you are brewing 4-cups or less, also select
SMALL BATCH. (Fig. 6).
7 Press BREW to start brewing. When the
brewing is complete, the unit will beep.
NOTE: Each brew has a pre-infusion cycle
with varying times. The brew will begin, pause
for a short period of time, and then continue
brewing. This pre-infusion cycle is used to
evenly saturate the coffee grounds.
PREPARING & USING YOUR NINJA® COFFEE BREWER
Integrated Ninja® Scoop
COFFEE MEASUREMENT CHART
BATCH SIZE
CUPS OF COFFEE
2 cups
Small Batch
(SMALL BATCH button on)
4 cups
6 cups
8 cups
Full Carafe
(SMALL BATCH button off)
10 cups
12 cups
Integrated Ninja Scoop is equivalent to 1 tbsp. of coffee.
GROUNDS
WATER
2 Ninja Scoops or 2 tbsp.
2-cup line
4 Ninja Scoops or 4 tbsp.
4-cup line
6 Ninja Scoops or 6 tbsp.
6-cup line
8 Ninja Scoops or 8 tbsp.
8-cup line
10 Ninja Scoops or 10 tbsp.
10-cup line
12 Ninja Scoops or 12 tbsp.
12-cup line
ninjakitchen.com
8