golmar Rock Serie Manual De Instalación página 66

DOOR PANEL INSTALLATION
D
oor panel configuration.
The door panel is provided with microswitches (SW1) and
a jumper (JP1) in its rear part; Their functions are
described below.
JP1
It allows the connection of an alternative current
door opener
diagram.
It allows the connection of a direct current door
opener;
diagram.
SW1
; page 80 shows th
page 80 shows the connection
When this switch is ON, the door panel can autoswitch-on (audio
and/or video communication without any call). In buildings with
several door panels, just activate this function in one of them. In
systems equipped with a general door panel, this function can be
activated in one door panel of each detached house.
Select ON for monitors and telephones programming. Once the
programming progress is finished return the switch to OFF position.
Pag e 72 describes monitors program method
describes telephones program method.
Select OFF in case of a main door panel. Each system must be
equipped with just one main door panel; all the others must be slave
door panels (ON). In systems provided with a general door panel,
one door panel of each house will be configured as main door panel.
Select OFF if the door panel is provided with a camera. Select ON if it
has no camera.
With a general door panel,
installation. Once the programming progress is finished return the
switch to OFF position.
Pa ge 79 describ es the program method.
Equip the installation with a
correct operation, this resistance must be activated only in the
panel which is the nearest to the backbone installation
general door panel (if one exists). If any RD-Plus/Uno SE repeater is
used it must be deactivated in the door panels behind it. ,
e connection
select ON to program the backbone
communication resistance.
65
; while pag es 74 and 78
To ensure a
door
or in the
*Factory value